Keep your engine clean!

our unique HHO oxyhydrogen-powered engine decarbonizing machine, can remove nearly all carbon build-up. in just 20 minutes, your engine will run like new.

The HHO Carbon Cleaning machine has a remarkable cleaning capacity. With this advanced technology, developed over several years, oxy-hydrogen is pulsed through the air intake pipes, burning off up to 75% of the carbon deposits that prevent your engine from running smoothly.

The HHO engine decarbonizer is easy to use, fast, efficient, and completely autonomous.
The heating effect of oxy-hydrogen makes it possible to raise the combustion temperature to trigger a pyrolysis, essentially a chemical reaction that serves to remove, burn off, disintegrate, and eliminate carbon deposits. To install, simply insert the hose of the Carbon Cleaning station into the air intake duct and then connect the clamps on to the positive and negative terminals of the vehicle’s battery. By activating the timer, you have the ability to choose the duration of the cleaning, which varies according to the contamination level of the vehicle. While the machine is operating, please allow the vehicle to idle.

 

Oxy-Hydrogen is characterized by a high reactivity and a combustion rate as much as five times greater than that of fuel. Moreover, oxy- hydrogen has a wider flammability range than other types of fuel. Due to these characteristics, the addition of even a small amount of oxy-hydrogen in the fuel-air mixture increases the combustion rate thus making the combustion more stable by reducing the duration of combustion and reducing cycle-to-cycle variations.

Many quantitative and experimental studies done on the impact of adding hydrogen in internal combustion engines (based on gas or diesel) have come to the common conclusion that the measure:

–          reduces the duration of the combustion process
–          increases thermal efficiency
–          burns off, disintegrates, and removes carbon deposits

And finally, for best results, we recommend you go for a 25 to 30-minute drive in low gear (above 3000 r/min) after the Carbon Cleaning session in order to remove the last remaining residue from the exhaust.

Add a Comment

Your email address will not be published. Required fields are marked *